Internship Student specialising in Injection Moulding / Research & Development / Engineering

-

Published : 1 Feb 2021 View Details

Senior Technician of Injection Moulding

1.Set-up/down mould accordance to production schedule.
2.Maintain good housekeeping in production areas.
3.Feedback any problem or damage to mould or equipment.
4.General maintenance of machine and equipment.
5.Service machinery parts, robot, auto-loaders, granulator, crusher, hopper, dryer, mold temperature controller.etc.
6.Carry out lubricant of machinery.
7.Assist his superior to test run new or modified mold for QC evaluation.
8.Resolve trouble-shoot machine and process problem.
9.Check water cooling pipes/hoses and prepare replacement of nipples/hoses for molding when required.
10.Ensure adherence to all safety precaution and procedure during set up/down mold.
11.Authorize person to stop the machine.

Published : 1 Feb 2021 View Details

QC Checker

1.Ensure daily QC inspections are being checked accordingly to establish quality system procedure and
part specification.
2.Conduct sampling check based on Plastico Sampling Table Standard.
3.Complete sampling check report to section HOD.
4.Highlight quality issue to In-Process QC (IPQC) to take corrective action if non-conforming part being
detected.
5.Ensure every status of part checked are being identified accordingly.
6.Ensure all non-conforming part are being identified and segregated from mixing with good parts.
7.Re-screen parts after sorting or rework.
8.Perform other duties as assigned by section HOD.
9.Ensure department 5S practice in accordance.

Published : 1 Feb 2021 View Details

Production Operator

1.Good housekeeping in the factory especially own work station area.
2.Visual check on molded parts during production.
3.Ensure that parts produced are packed in cartons and packaging is labeled accordingly.
4.Follow instruction from Line Leader.
5.Inform Line Leader or Supervisor when there is machine alarm, stoppage or defect is found.
6.Handle products with care to avoid scratched and damages.

Published : 1 Feb 2021 View Details

Switch To Desktop Version